Windows xp cannot connect to wireless network validating identity

There's no WPA2 on the card, just WPA and WPA-PSK: WPA-PSK was the only setting that would let me enter a network key.

I had TKIP and AES as options there, but cipher type is AES on the router, so I chose that.

In any event I am finding that after rebooting the WPA2 code is no longer there and it has reverted back to Open WEP.

I also tried the option: Network And Internet -- Add a wireless device to the network but again nothing is found I downloaded this: and nothing seems to have changed.

This article describes the steps necessary to connect to your Cradlepoint through your computer.

Your computer only allows one network connection at a time.

First of all I tried to connect using the built-in wireless, even after updating the driver, no network is found.

I then tried installing the supplied Sitecom N adapter, after some problems the network appears but I can't connect, I am told "Windows was unable to find a certificate to log you onto the network" I read several threads that led me to uncheck "Enable IEEE 802.1x authentication for this network" and I actually managed to enter the WPA2 code but this just leads to the message "This connection has limited or no connectivity" and "validating identity".

windows xp cannot connect to wireless network validating identity-84windows xp cannot connect to wireless network validating identity-51windows xp cannot connect to wireless network validating identity-84

I can't figure out why I can't get it up and running now.Note: For different operating system, there might be sometimes problem to connect the wireless.Here are some issues that you may easily face: For windows XP: 1.This means that you will have to disconnect (unplug) the cellular modem (aircard) from the computer and close the cellular connection manager tool provided by your cellular carrier or, disconnect from any LAN (wired Ethernet) or Wi-Fi (wireless) connections before you will be able to connect your computer to the router either by Ethernet cable or Wi-Fi.By default, the wifi SSID will always be the model of the Cradlepoint router separated by a (-) and then the last 3 of the routers MAC address.